Baumfolder Baumcut Programmable 26.4 Manual de usuario descargar pdf (Pagina 93)

K6 - 5

The BAUM sinus cutting stick is made of high resistance plastic material.

Due to the unusual wavy design a tight fitting in the table grove is assured

without the need for glue or screw.

Each cutting stick is useable 4 times as they are turned around.

Removing of cutting stick

Tool needed: normal screw driver

1. Lift cutting stick slightly on the left side cutting stick stop

2. Prey out cutting stick carefully from left toward the right.

Clean cutting stick table grove!

Inserting of cutting stick

1. Rest cutting stick end against the right stop and work into the grove

2. Follow the wavy form of the cutting stick when pressing into the table

grove. Press down hard to assure total seating of stick.

6.0 Knife Change

Changing of cutting stick

normal turn over replace

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 103 104

Sin comentarios

Baumfolder Baumcut Programmable 26.4 Manual de usuario Pagina 93