Baumfolder Baumcut Programmable 26.4 Manual de usuario descargar pdf (Pagina 70)

K5B - 10

Selection of Block Programming with key

Block Programming = automatic programming

Blcok Programming is fitted with graphic operator prompting for the automatic

generation of a cutting program for printed and unprinted sheets.

The required cutting sizes and remarks are automatically stored in a free pro-

gram.

There are 3 variations of Block Programming with up to 8 available block

programming modes. The selection of a variation is done by cursor keys.

Variation 1: Size cut with edge trim entry

Consisting of: 1 Angular cut

2 Four edge trim

3 Four edge trim with labels

Variation 2: Size cut with final size entry without edge trim entry (with

the possibility of edge trim preadjusting)

Consisting of: 1 Final size angular cut

2 Final size four edge trim

3 Final size trim with labels

Variation 3: Size cut with optimisation of final size trim with labels

without edge trim entry (with the possibility of edge trim

preadjusting)

Consisting of: 1 Final size optimisation

2 Four-size trim with labels and trim cuts

Block Programming

5.0 Automatic Operation

(with edge trim preadjusting)

Variation 1

Variation 3

Variation 2

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 103 104

Sin comentarios

Baumfolder Baumcut Programmable 26.4 Manual de usuario Pagina 70